张力腿平台筋腱支撑浮筒结构设计研究     

王火平  金文学  吕东  范志峰  王立权 《海洋工程》2018,36(3):69-75

在张力腿平台筋腱与海底桩基连接后,需要筋腱支撑浮筒为筋腱提供足够的浮力,保证筋腱在平台运抵工作海域之前不会发生倾覆。针对南海油田自主研发的张力腿平台筋腱实际尺寸及设计要求,设计了适用于1 061 mm(40英寸)筋腱、500米水深的张力腿平台筋腱支撑浮筒,并对筋腱支撑浮筒主要受力进行了分析计算,根据所计算的载荷情况对关键部件进行了有限元仿真分析,验证了结构强度的可靠性,并得到了结构的应力集中点与最大变形点,为筋腱支撑浮筒的结构设计提供了参考。  相似文献   

Second-order random interfacial wave solutions for two-layer fluid with a free surface     

SONG Jinbao  SUN Qun 《海洋学报(英文版)》2006,25(1):15-20

1 Introduction Interfacial waves travelling along the interface between two fluids of different densities can be often observed in subsurface layers of the ocean since the upper subsurface layer is warmer over much of the o- cean (Umeyama, 2002). They are…  相似文献   

Analytical investigations on loop-manoeuvre of underwater towed cable-array system   总被引：3，自引：0，他引：3  

Srivastava Shyam Kishore  C. Ganapathy 《Applied Ocean Research》1996,18(6):353-360

The paper reports on analytical case studies on the loop manoeuvre of an underwater towed cable-array system to give an insight into the tactical aspects of their naval applications. The analytical formulation and the solution procedure adopted for this three dimensional dynamic problem is also described. The case studies have been carried out for different loop radii, tow lengths, tow speeds and truncated loops. The resulting X,Y,Z co-ordinates of the towed cable-array and tow-point tensions have been computed. Based on these results, the tow-length to loop radii ratio, leading to cable-array system looping, has been found. The values of speed reduction and turning radius, causing dangerous relaxation in tow-point tension have been worked out. After exit from the loop, the timing required for realignment of the cable-array system with the ship's heading can be obtained from plots of the results. These timings help to plan ship manoeuvres to optimise reestablishment of stable listening conditions during underwater surveillance.  相似文献   

海洋中液-固界面作用的分形研究Ⅰ.SAXS法测量固体交换剂的分维     

张正斌  管清录  郭国霖  刘莲生  王超英 《海洋与湖沼》1992,23(2):138-143

本文将分形作为一个新概念,应用到海洋化学的液-固界面作用的一系列的研究上。根据用SAXS法测定一些常见的粘土矿物(高岭石,蒙脱石)和水合氧化物(水锰矿、δ-MnO_2、氧化铁凝胶、针铁矿、无定形氧化铁)的分维结果,可将这些结果划分成三类:(1)小尺度模量下具有表面分形;大尺度模量下具有质量分形。(2)只有一种分维值的表面分形。(3)在小尺度模量下和大尺度模量下分别具有不同分维值的表面分形。  相似文献   

波浪作用下潜标拖缆动力学分析     

朱刚  杜月中 《海洋工程》2007,25(4):15-20

对三维潜标拖缆在规则波作用下的动力响应进行了研究,首先基于集中质量法给出了缆绳在规则波作用下的控制方程,然后提出了两种不同类型的自由端边界条件:质点型和艇型自由端边界条件,前者把拖体视为作三个自由度线运动的质点,而后者把拖体视为作六自由度运动的艇体,最后用有限差分法进行了数值研究。数值计算结果表明潜标拖缆在规则波的作用下,不仅作近似的简谐振动,还会在横向、垂向产生一个偏移量,该偏移量的大小随浪向角的变化而变化,另外受遭遇频率的影响,振动的幅值也随浪向角的变化而呈现不同的特征。  相似文献   

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns   总被引：6，自引：0，他引：6  

N.L. Watts   《Marine and Petroleum Geology》1987,4(4)

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.  相似文献   

The mass accommodation coefficient of ammonia on water     

A. Bongartz  S. Schweighoefer  C. Roose  U. Schurath 《Journal of Atmospheric Chemistry》1995,20(1):35-58

The mass accommodation coefficient of ammonia gas on water has been determined by measuring the absorption rate of 50–200 ppm NH₃ in one atm of air or helium into a liquid jet of 97 µm diameter as function of the exposed jet length, and comparing the results with numerical simulations which treat as the only free parameter. The model considers in detail transport of NH₃ by molecular diffusion, penetration of the gas/water interface, hydrolysis in the acidified water, and transport of the solutes from the surface into the jet. A correction is applied for the time evolution of the jet surface speed, using literature data on the fluid mechanics of liquid jets. The result of nine sets of independent measurements is

相似文献    8. Tectonically driven fluid flow and associated low-grade metamorphism during the Alpine compression in the eastern Iberian Chain (Spain)      J.D. Martín-Martín  J. Tritlla  E. Cardellach  D. Gmez-Gras 《Journal of Geochemical Exploration》2006,89(1-3):267 Fluid inclusions and clay mineralogy of the Permo-Triassic rocks from the Espina and Espadà Ranges (SE Iberian Chain, Spain) have been investigated to establish their relationship with hydrothermal fluid circulation during the Alpine Orogeny. Primary fluid inclusions in quartz-filled tension gashes in Permo-Triassic sandstones reveal maximum temperatures around 230 °C and very constant salinities of 8.5% wt. eq. NaCl. Secondary fluid inclusions found in quartz from the Santonian Ba–Cu–Hg deposits show similar compositional and thermodynamic characteristics, denoting an Alpine recrystallization. Clay mineral composition of Permo-Triassic mudrocks is characterized by pyrophyillite, indicating low-grade metamorphic conditions. Field observations and experimental data suggest that the crystallization of quartz in tension gashes, the formation of secondary fluid inclusions and the development of the metamorphism are contemporaneous and related to fluid circulation during the Alpine compression. Fluid flow took place along the Hercynian fault system that was reactivated during the Mesozoic rift stage and inverted during the Alpine deformation.  相似文献    9. 裂缝性岩石裂缝扩展的光弹构造物理模拟——以南华北盆地户部寨沙河阶组为例   总被引：1，自引：0，他引：1       下载免费PDF全文 颜丹平  周美夫  田崇鲁  汪昌亮  张建增  郭庆银  马寅生  董铁柱 《地质学报》2005,79(5):602-607 以南华北盆地户部寨第三系沙河阶组粉砂岩低渗透储层为例,总结了其中发育的5种类型构造裂缝组合,即:①南北向雁形张节理组成的共轭剪节理带;②东西向雁形张节理组成的共轭剪节理带;③缠结状多组剪切构造裂缝;④组合状交切的多组剪切构造裂缝及张裂缝;⑤散状无序排列的构造裂缝。在此基础上,建立光弹性试验构造物理模型,沿现应力场96°方向,均匀地对该模型逐步增加外载力。结果表明,沿各组合裂缝尖端分别形成对称于裂缝走向、且主轴垂直于裂缝的Ⅰ型等色线条纹;对称于裂缝走向、且主轴平行于裂缝走向的Ⅱ型条纹和斜交于裂缝走向的复合型(Ⅲ型)条纹。第①类组合裂缝尖端以Ⅰ型等色线条纹的拉张应力和张剪应力为主;第②类组合裂缝尖端以复合型(Ⅲ型)等色线条纹的挤压应力为主;第③、④和⑤类组合裂缝尖端的应力分布较为复杂。当模型外载荷接近1000kg时,裂缝尖端起裂,并开始发育显微裂缝,而当外载荷达1100-1200 kg时,沿裂缝尖端部位形成宏观裂缝,并开始扩展。5种类型的裂缝组合扩展发育程度由强至弱依次为:①,③,⑤,②,④。其中第①类共轭裂缝组合起裂最早,扩展最快,裂缝间的连通趋势最好,说明规则分布的构造裂缝组合,在垂直于外施加载衙时更易达到连通的目的。  相似文献    10. Cyclic tests on large‐scale models of existing bridge piers with rectangular hollow cross‐section      A. V. Pinto  J. Molina  G. Tsionis 《地震工程与结构动力学》2003,32(13):1995-2012 Cyclic tests on two large‐scale models of existing bridge piers with rectangular hollow cross‐section were performed in the ELSA laboratory. The prototype structure is an existing reinforced concrete highway bridge constructed in Austria in 1975. The piers presented several seismic deficiencies and consequently they showed poor hysteretic behaviour and limited deformation capacity as well as undesirable failure modes that do not comply with the requirements of modern codes for seismic‐resistant structures. Experimental data are compared to numerical and empirical predictions. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献    1 [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] 下一页 » 末  页»